Brass Spring Flake Adjuster and Spring Bender – Alignment & Regulator Combo For Coil Tattoo Machines
Specifications:
- Quantity: 1 adjuster
- Material: Brass
- Net Weight: 220g
- Dimension: 82.6mm x 30mm x 30mm.(L*W*H)
- Used to align your armature bar with front & back springs
- Follow directions below on bending the spring & aligning springs with armature bar
Description
Brass Alignment & Regulator Combo For Coil Tattoo Machines – Spring Flake Adjuster & Bender
This spring flake adjuster and spring bender can be used to align your armature bar with your front and back springs. It is a great tool to have in order to fine tune your machines. The adjuster & bender is made of brass and its net weight is approximately 220grams. It is 82.6mm (L) x 30mm (W) x 30mm (H). You can follow the directions below on how to bend the springs and then how to align the springs with the armature bar. Also, see the gallery of images for a detailed How-To picture for adjusting the alignment.
How to bend the springs?
- Open the spanner slightly.
- Put the front spring into the slot.
- Pull out the latch.
- Pull the latch and press the spanner in opposite directions.
- Press the spring to be bent (Please note: should not be bent more than45°)
How to align the springs and the armature bar?
- Bend the spring per instructions above. Screw on the front and back springs. Install o-ring.
- Adjust the latch position and place the armature bar & spring flake into the slot.
- Push the latch and place the armature bar & spring inside until they are in-line.
- Use the allen wrench to tighten the screw.
- Align spring, armature bar, & needle pin in a line.
- The springs & armature bar should now be aligned.
Related products
-
Copper 8/32 Threading Binder Set
0 out of 5(0)Specifications:
- 4 Piece Set: Includes front binder, rear binder, thumbscrew, contact screw
- Manufactured by Baltimore Street Irons
- Rear binder screw comes with a hole on the end for standard mount and a hole on the side for side mount
- Threading: All 8/32″ Threads
- Matieral: Copper (All items are made of copper)
-
Copper Front Binding Post Screw – M4 Metric – Version 1
0 out of 5(0)Specifications:
- Quantity: 1 screw
- Size: 13mm total length, 8mm for threaded area length
- Material: copper
- M4 metric
- 7mm thread length
- For front binding posts
- Manufacturer: Precision
Note :Available in version 2,6
-
Specifications:
- Quantity: 1 set up contains 7 pieces
- Brass contact and binding post
- Metric threading
- Build your own
- Manufacturer: Precision
-
Snug Fit Rubber Nipples – Bag of 100 – Tattoo Supplies
0 out of 5(0)Specifications:
- Quantity: 1 bag of 100 nipples
- Material: black rubber
- Use to keep needle in place
- Lightweight and easy to use
- Manufacturer: Precision
-
Brashness Brass Binding Post Set – M4 Metric
0 out of 5(0)Specifications:
- Quantity: 1 binding post set
- Material: brass
- Set includes: (2) screws, (3) washers, (1) contact screw, (1) front binding post
- M4 Metric
- Manufacturer: Precision
-
Specifications:
- Quantity: 1 screw
- Material: steel
- 13mm length
- 4mm diameter of threaded part
- 7mm thread length
- For springs or armature bar
- Manufacturer: Precision
Reviews
There are no reviews yet.